Rashid
Rashid
@rashid
Eminent Member
Joined: Apr 27, 2024
Last seen: Aug 7, 2025
Topics: 3 / Replies: 13
Reply
RE: What is bandwidth in oscilloscope?

You're right—3x can be fine for clean sine waves. The 5x rule is mainly for digital signals or sharp edges where higher harmonics matter more. Depends...

6 months ago
Forum
Reply
Answer to: Can anyone suggest a new ESP32 board?

Yeah, there are a few interesting new ESP32 boards out lately. If you're looking for something cutting-edge, check out the ESP32-P4 series. The ESP32-...

7 months ago
Forum
Reply
Answer to: How can I secure my IoT devices from hacking?

Yeah, securing IoT devices is super important, especially since they're often connected to the internet with minimal protection. Here are a few good p...

9 months ago
Topic
Replies: 0
Views: 1295
Reply
Answer to: BJT VS MOSFET- Current controlled vs Voltage controlled

The most important difference between a BJT and a MOSFET lies in their control mechanism. A BJT is a current-controlled device, meaning it requires a ...

9 months ago
Reply
Answer to: What is signal sampling in ADC?

Signal sampling is the process of measuring an analog signal at regular intervals so it can be converted into digital form by an ADC (Analog-to-Digita...

10 months ago
Reply
Answer to: RS232 vs. UART – What’s the difference?

The following points highlight the major differences between UART and RS-232: UART (Universal Asynchronous Receiver-Transmitter) is a hardware m...

11 months ago
Forum
Reply
Answer to: Can a thermal camera help in circuit troubleshooting?

Yes, a thermal camera is a valuable tool for verifying thermal design and identifying anomalies in high-power circuits. It helps ensure components dis...

12 months ago
Reply
Answer to: What is bandwidth in oscilloscope?

Bandwidth in an oscilloscope refers to the maximum frequency it can accurately measure. It is typically defined as the frequency at which the amplitud...

12 months ago
Forum
Reply
Answer to: Li-ion vs. Li-Po Batteries: Which One Should I Choose?

If you need a battery with better durability, longer lifespan, and stable power delivery, go with Li-ion—ideal for general electronics and low to mode...

1 year ago
Reply
Answer to: How to Connect Multiple Sensors to a Single Arduino Pin?

To connect multiple sensors to a single Arduino pin, you can use analog multiplexers like the CD74HC4067 for switching between sensors or voltage divi...

1 year ago
Forum
Reply
Answer to: Good circuit simulation softwares- Any suggestions?

The best choice of software depends on your specific needs. Consider factors such as the complexity of your circuits, your experience level, and wheth...

1 year ago
Forum
Topic
Reply
Answer to: Where can I learn more about direct port manipulation for controlling GPIO pins?

This video is an absolute gold. Thank you for sharing it. To learn more about architecture, what's the best way?

2 years ago
Forum
Page 1 / 2