Notifications
Clear all
Search result for: WA 0812 2782 5310 [[Pandawa Mural]] Biaya Jasa Lukisan Mural Grafiti Png Kartasura Sukoharjo
Page 2 / 2
Prev
Hi,
Sorry for such a silly question but I am very new to Arduino.
In the circuit, there is a resistor connected to the LDR. I don't quite understand its use. For LED I get it, to limit the current. But why with the LDR. Can't we directly connect it to the 5V and then to the analog pin??
Thanks very much.
If found this circuit here.
Attachment : Arduino-LDR-circuit.png
... due to its low cost, small size, and decent processing power. The ESP8266 itself is just a chip, and while you can use it directly, it’s typically integrated into modules or development boards for easier use.
NodeMCU: This term means two things:
NodeMCU Development Board: This is a development board that features the ESP8266 chip (typically the ESP-12E or ESP-12F module). The NodeMCU board makes it easier to work with the ESP8266 chip by providing additional features like USB-to-serial conversion, a power regulator, and easy access to the GPIO (input/o ...
Imagine you have a button connected to your Arduino. You WAnt the Arduino to know when the button is pressed or not. Without a pull-up or pull-down resistor, when the button is not pressed, the input pin might randomly read HIGH or LOW because it’s floating—picking up noise from the environment. This makes it hard for the Arduino to know if the button is actually pressed or not.
What Does "Pull-Up" and "Pull-Down" Mean?Pull-Up Resistor: It "pulls" the input pin to a HIGH state(like ON). To use it, simply connect a big value resistor(say 10K ohm) in series w ...
Page 2 / 2
Prev